CRM Mitchell1, Author at Cambridge Auto Center

2015 Toyota Tacoma
Mileage
79,461
Service Date
1/12/2019
Services Performed
5,000 MILE MAINTENANCE INSPECTION OIL CHANGE STICKER REQUIRED 22-Point Safety Inspection, Drain oil, replace drain plug gasket and oil filter. Check tire pressure. Check all exterior lights. Road Test.
STATE INSPECTION
REMOVE AND INSTALL CABIN FILTER DUE TO MILEAGE AND MAINTENANCE.
MARY ELLEN D. gave our service a 5 star review on 1/12/2019
2012 Nissan Rogue
Mileage
90,965
Service Date
12/20/2018
Services Performed
3,000 MILE MAINTENANCE INSPECTION OIL CHANGE STICKER REQUIRED 22-Point Safety Inspection, Drain oil, replace drain plug gasket and oil filter. Check tire pressure. Check all exterior lights. Road Test.
IVAN P. gave our service a 5 star review on 12/22/2018
2013 Nissan Maxima
Mileage
106,858
Service Date
12/15/2018
Services Performed
SERVICE REQUEST–ESTIMATE FOR SPARK PLUGS AND FUEL INJECTION SERVICE–PREVENTATIVE MAINTENANCE
SPARK PLUGS – Remove and Replace – All Applicable Models
PREMIER FUEL INJECTION SERVICE SPECIAL: Clean fuel Injectors. Clean IAC motor as required. Clean throttle body intake. Visually inspect vacuum lines and connections. De-carbonize intake manifold, combustion chamber, pistons, intake valves and exhaust valves. Reset base manifold.
RAUL A. gave our service a 5 star review on 12/20/2018
2005 Lexus RX 330
Mileage
234,627
Service Date
11/30/2018
Services Performed
HEADLAMP BULB – Remove and Replace – One Side
MARIO G. gave our service a 5 star review on 12/13/2018
2008 Nissan Altima
Mileage
175,265
Service Date
11/7/2018
Services Performed
DIAGNOSE: FOUND TRUNK DAMAGE, DOESN'T LOOK CLOSED. W/S DAMAGE, PASSENGER DASH DAMAGE, PASSENGER SIDE TPMS LITE IS ON PRESSURE HOSE IS LEAKING —————————————————————————————— Road test vehicle under above conditions to verify customer complaint, Raise vehicle, locate source of concern, Report finding to customer, COMPLETE SERVICES AS DISCUSSED WITH CUSTOMER. THANK YOU FOR CHOOSING CAMBRIDGE FOR YOUR AUTOMOTIVE NEEDS
NITHIN K. gave our service a 5 star review on 11/9/2018
2013 BMW 335i
Mileage
73,124
Service Date
11/6/2018
Services Performed
STATE INSPECTION
BRAKE LIGHT BULB – Remove and Replace – One
LARRY L. gave our service a 5 star review on 11/9/2018
2010 Ford Pickup
Mileage
101,776
Service Date
11/7/2018
Services Performed
DIAGNOSE: Road test vehicle under above conditions to verify customer complaint, Raise vehicle, locate source of concern, Report finding to customer, COMPLETE SERVICES AS DISCUSSED WITH CUSTOMER. THANK YOU FOR CHOOSING CAMBRIDGE FOR YOUR AUTOMOTIVE NEEDS
REMOVE AND INSTALL AC CONDENSOR DUE TO LEAKING.
Basic Air conditioning service Includes: Test system for proper refrigerant, moisture and contamination. Inspect and adjust A/C drive belts. Fully charge system to inspect all visible components for leaks using electronics leak detectors. Add refrigerant dye for slow and very hard to detect leaks to be possible to detect if the system loses its charge. Test A/C system for operation and performance. NOTICE: Performing this service in no way implies that your system is totally free of any malfunction or undetectable leaks. We can only verify the condition of your system at the time of the test. We can't predict future malfunction. This Service was performed in order to test and diagnose your system operation and in order to do an estimate for your review. FEDERAL 1990 CLEAN AIR ACT prohibits repair facilities from adding refrigerant to or leaving refrigerant in any system that is known to have a leak.
REMOVE AND INSTALL SPARK PLUGS AND BOOTS DUE TO MILEAGE AND MAINTENANCE.
PREMIER FUEL INJECTION SERVICE SPECIAL: Clean fuel Injectors. Clean IAC motor as required. Clean throttle body intake. Visually inspect vacuum lines and connections. De-carbonize intake manifold, combustion chamber, pistons, intake valves and exhaust valves. Reset base manifold.
REMOVE AND INSTALL O2 SENSOR DUE TO CODE BANK 2 SENSOR 1(UP STREAM)
Road test and verify engine performance, transmission operation, and shift patterns. Flush transmission which includes: flushing of transmission cooler, cooler lines, valve body, and torque converter. Flush all contaminated fluid out and replace with new fluid.
Road test for power steering operation. Inspect system for leaks. Flush power steering lines, pump, rack and pinion, and or gear box. Install new power steering fluid. Throroughly clean all internal part's. Flush out all contaminated power steering fluid and replace clean fluid. Install power steering additive to revitalize seals and O-rings. Road test vehicle for proper power operation.
COOLING SYSTEM FLUID FLUSH: Pressure test, cooling system and inspect for leaks. Our cooling system Power Flush continuously forces coolant under pressure through the engine, radiator and heather core in both directions at different times. Simultaneously, it forces the coolant through 25- 5- micron filters to remove contaminants. Flush engine, radiator and heater core in both directions. Bring antifreeze to -35 degrees. Test pH level. Balance coolant pH level between 9.8 and 10.5. Visually inspect radiator-cooling fan for proper operation. Check heater operation.
DIFFERENTIAL FLUSH FRONT and REAR Front and rear diffeential flush. Refill with new synthetic differential fluid.
3,000 MILE MAINTENANCE INSPECTION OIL CHANGE STICKER REQUIRED 22-Point Safety Inspection, Drain oil, replace drain plug gasket and oil filter. Check tire pressure. Check all exterior lights. Road Test.
Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean. (This service will help reduce effects of electrochemical degradation which can damage brake components) Top off master cylinder. Road test for proper operation.
GERARDO R. gave our service a 5 star review on 11/12/2018
2010 Toyota Corolla
Mileage
127,586
Service Date
11/10/2018
Services Performed
5,000 MILE MAINTENANCE INSPECTION OIL CHANGE STICKER REQUIRED 22-Point Safety Inspection, Drain oil, replace drain plug gasket and oil filter. Check tire pressure. Check all exterior lights. Road Test.
Precision Front wheel alignment. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check caster and camber angles and adjust as required. Check and set toe-in as required. Center steering wheel. 90 DAY WARRANTY ON ALIGNMENT
CATHERYN P. gave our service a 5 star review on 11/12/2018
2007 Kia Optima
Mileage
100,406
Service Date
11/3/2018
Services Performed
5,000 MILE MAINTENANCE INSPECTION OIL CHANGE STICKER REQUIRED 22-Point Safety Inspection, Drain oil, replace drain plug gasket and oil filter. Check tire pressure. Check all exterior lights. Road Test.
STATE INSPECTION
REMOVE AND INSTALL BELT, IDLER AND IDLER TENSIONER DUE TO GROOVED IDLERS/TENSIONER PULLEY.
WALLACE D. gave our service a 5 star review on 11/6/2018
2006 Toyota Camry
Mileage
77,054
Service Date
11/1/2018
Services Performed
REMOVE AND INSTALL RACK AND PINION DUE TO SEEPING FLUID FROM BELLOWS BOOT
Precision Front wheel alignment. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check caster and camber angles and adjust as required. Check and set toe-in as required. Center steering wheel. 90 DAY WARRANTY ON ALIGNMENT
Road test for power steering operation. Inspect system for leaks. Flush power steering lines, pump, rack and pinion, and or gear box. Install new power steering fluid. Throroughly clean all internal part's. Flush out all contaminated power steering fluid and replace clean fluid. Install power steering additive to revitalize seals and O-rings. Road test vehicle for proper power operation.
REMOVE AND INSTALL D/S DUST SHIELD
5,000 MILE MAINTENANCE INSPECTION OIL CHANGE STICKER REQUIRED 22-Point Safety Inspection, Drain oil, replace drain plug gasket and oil filter. Check tire pressure. Check all exterior lights. Road Test.
Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean. (This service will help reduce effects of electrochemical degradation which can damage brake components) Top off master cylinder. Road test for proper operation.
WASH OFF OIL LEAKS AND ADD DYE TO DETERMINE WHERE LEAK IS COMING FROM
STATE INSPECTION
ALEXANDER C. gave our service a 5 star review on 11/1/2018

CRM Mitchell1

We Service and Repair all CRM Mitchell1 cars