2013 Ford F-150
Mileage
117,154
Service Date
4/30/2020
Services Performed
- 5,000 MILE MAINTENANCE INSPECTION OIL CHANGE STICKER REQUIRED 22-Point Safety Inspection, Drain oil, replace drain plug gasket and oil filter. Check tire pressure. Check all exterior lights. Road Test.
- BATTERY SERVICE, TERMINAL CLEAN
- Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean. (This service will help reduce effects of electrochemical degradation which can damage brake components) Top off master cylinder. Road test for proper operation.
- COOLING SYSTEM FLUID FLUSH: Pressure test, cooling system and inspect for leaks. Our cooling system Power Flush continuously forces coolant under pressure through the engine, radiator and heather core in both directions at different times. Simultaneously, it forces the coolant through 25- 5- micron filters to remove contaminants. Flush engine, radiator and heater core in both directions. Bring antifreeze to -35 degrees. Test pH level. Balance coolant pH level between 9.8 and 10.5. Visually inspect radiator-cooling fan for proper operation. Check heater operation.
- DIAGNOSE: Road test vehicle under above conditions to verify customer complaint, Raise vehicle, locate source of concern, Report finding to customer, COMPLETE SERVICES AS DISCUSSED WITH CUSTOMER. THANK YOU FOR CHOOSING CAMBRIDGE FOR YOUR AUTOMOTIVE NEEDS
- DRAIN AND FILL TRANSMISSION AND CHANGE FILTER WITH PAN GASKET DUE TO DIRTY FLUID.
- Front & Rear Differential fluid flush. Refill with new synthetic differential fluid.
- Precision Front wheel alignment. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check caster and camber angles and adjust as required. Check and set toe-in as required. Center steering wheel. 90 DAY WARRANTY ON ALIGNMENT
- PREMIER FUEL INJECTION SERVICE SPECIAL: Clean fuel Injectors. Clean IAC motor as required. Clean throttle body intake. Visually inspect vacuum lines and connections. De-carbonize intake manifold, combustion chamber, pistons, intake valves and exhaust valves. Reset base manifold.
- REMOVE AND INSTALL AIR FILTER
- REMOVE AND INSTALL FRONT STRUTS DUE TO CUPPING TIRES
- REMOVE AND INSTALL O2 SENSOR BANK 1 SENSOR 1 (PASSENGER SIDE) DUE TO CODE.
- REMOVE AND INSTALL PASSENGER FRONT DIFF AXLE SEAL SEEPING
- REMOVE AND INSTALL REAR SHOCKS DUE TO ORIGINAL EQUIPMENT
- REMOVE AND INSTALL SPARK PLUGS DUE TO MILEAGE AND MAINTANCE
- REMOVE AND INSTALL UPPER AND LOWER RADIATOR HOSES DUE TO MILEAGE AND MAINTANCE
- TRANSFER CASE SERVICE Drain and Refill transfer case with manufacturer's recommended fluid. Road test vehicle to verify no leaks at fill or drain plug.
TIM S. gave our service a 5 star review on 5/12/2020
